The meaning, function and structural char
    The meaning, function and structural characteristics of sink rolls scraper Sink rolls are commonly used equipment in industrial furnaces. Many friends do not know much about sink rolls scraper device, which is an important auxiliary equipme...
Requirements for the use of zinc pot sink
    Requirements for the use of zinc pot sink rolls, stabilizer rolls, and shaft sleeve materials in galvanizing production lines Galvanizing production line: The shaft sleeve and bearing bush are installed between the sink rolls and the stabil...
Analysis of Failure Causes of Surfacing M
    Analysis of Failure Causes of Surfacing Materials for Composite Remanufactured Sink Rolls The influencing factors and laws of the mechanical properties of surfacing deposited metal were analyzed. Firstly, the reasons for the failure of the...
Cost-effective comparison of different su
    Cost-effective comparison of different surfacing technologies for sink rolls For many sink rolls surfacing, the main thing is that they have different performance requirements. Generally speaking, for most of the surfacing welding of sink r...
What kind of mechanical seals are used in
    What kind of mechanical seals are used in sink rolls Sink rolls are a common type of industrial equipment, most commonly seen are hot-dip galvanized sink rolls or stainless steel sink rolls. It is usually used in the printing industry and h...
Refractory anchors and anchor bricks
    Refractory metal anchors, due to their own characteristics, limit the application of anchors at high temperatures. In order to meet the application of unshaped refractory materials in high temperature furnaces (above 1300 C), high alumina a...
Introduction of refractory anchors
    In todays booming refractory castables, the problem of construction anchoring has also become a concern, because the anchors play a role in enhancing the robustness of the refractory castables, so the performance of the anchors directly affe...
Introduction of L-type anchor
    L-shaped anchor nails. L-shaped nails are mostly used in the top of the furnace, and are suitable for single-layer furnace insulation structure. Due to the particularity of the top of the furnace, during the construction of the furnace roof...
Cleaning step of the bottom roller heat-d
    The bottom roller cooling bearing cleaning is divided into two steps: rough cleaning and fine cleaning. They are placed in the container respectively. First, the metal mesh is placed on the bottom to make the bottom roller heat-dissipating b...
Cleaning of the bottom roller heat-dissip
    When the bottom roller heat-dissipating bearing is cleaned, the bottom roller heat-dissipating bearing should be removed. Firstly, the appearance of the bottom roller heat-dissipating bearing is recorded, and the residual amount of lubricant...
Centrifugal casting roll bonding layer sl
    Centrifugal casting is a very important casting process. Many workpieces can be formed by centrifugal casting. In order not to affect the quality of the rolling, the centrifugal casting rolls are thoroughly inspected. It is found that the ce...
Centrifugal cast tube coating ratio
    The composition and weight ratio of the centrifugally cast tubular coating are: 100 parts of base material, 100 to 120 parts of water, 5 to 8 parts of bentonite, 0.15 to 0.3 parts of Na2CO3, and 0.1 to 0.3 may be added. An anionic surfactant...
Copyright © 2016 Hexin Machinery All Internet        Sitemap