Technology Introduction of Pouring Part 2
    Casting technology on the basis of traditional casting, derive perfusion, potting, pressure casting, such as rotating casting and centrifugal casting method.(3) pressure casting.When casting a certain pressure for the material, is beneficial...

One of The Advantages of The Steel Struct
    Steel structure manufacture process, the important force nodes often have many weld penetration testing.Traditional welding process is carbon arc air gouging opposite qing, in recent years, the steel structure industry began to use welding c...

The Second of The Advantages of The Steel
    In recent years, the steel structure industry began to use welding ceramic liner from the root process, it is a kind of weld groove opposite after laying welding ceramic liner for welding on the front and reverse side weld force forming, mak...

Investment casting iron plate testing met
    Investment casting iron plate testing method1. The ratio of cast iron plate contact areaWill be shown on the inspection on your tablet work cant agent, on not less than the accuracy grade of flat grind together, in the checked plate shows c...

Investment casting iron plate testing met
    2. Cast iron flat plane wave momentumThe plane wave gauge on the tablet, along arbitrary direction of a linear motion plane wave instrument. Mobile distance for tablet half the length of the diagonal and should not be less than 200 mm. Take...

Deformation of Investment Castings
    Flaring deformation: the forming reason is in the opening size of sand core and sand mold hindered the contraction of the casting, plastic deformation in the casting mouth free structural part, resulting in a flaring deformation defects.Warp...

Investment Casting Trace From The Deforma
    Trace the casting deformation is divided into: deformation, casting the flaring of deformation and warping deformation.Trace the deformation: alloy materials, gray cast iron is the most easy to trace the deformation.Grey cast iron shakeout...

Investment Casting Deformation Suggested
    For precision casting deformation ask advice measures:Find mold to shoot before 1. Shoot the wax wax room presets, until the mold temperature and shot wax wax room temperature phase began to shoot at the same time;As for the back shell makin...

Investment Casting Deformation Suggested
    3. Blow-in, module when high temperature also should avoid to overlap, do it regularly, so that the deformation in the same direction for plastic correction fashion clip.4. Calibration fixture should use hard material, casting surface wear r...

The Key Points of Heat Treatment Process
    The main technological factors of casting steel heat treatment:1. Steel heat treatment consists of three stages: heating, heat preservation and cooling.The determination of its parameters are in place to ensure that the product is based on t...

Investment Casting Process
    Pressure wax (shoot wax wax models) - repairing wax, wax inspection group - tree (la module tree) - shell making (first moistening slurry, spray sand, pulp, the final mould shell with air drying) - dewaxing (steam dewaxing) -- - casting mol...

The Usage of Aluminum Casting Products
    Pure aluminum is very soft, intensity is small, has the very good ductility, can be pulled into filaments and pressed into a foil, a large number of used in the production of wire, cable, radio industry packing and so on.It is about two thir...