Careful friends can see, there will be a layer at the surface of centrifugal casting coating, this is in order to make the workpiece get the best state.And about the operation of centrifugal casting coating process, and have less people know?The following is the basic content of related.When casting workpiece need to baking mold, will have to get rid of the water vapor and by improving the die temperature to prevent explosion spatter.Baking torch or available ways to operate, such as red iron and it's ready for paint drying.Next step is to clean mold operation, to promote the asbestos pad, superior and lock the front end cover, burner, etc.The paint with coating tube into a mould, wait for paint to dry shell can be after pouring, but note that coating tube into the spinning front end cover easily and have an accident, so in coating tube drawn at the same time in the drive to start the machine rotation, to ensure safety.Pouring is completed, in order to get refined grain, can be appropriately of spray cooling, but attention should be paid to the control of temperature and time, to avoid affect the thickness of the coating.